SWITCH IS CENTER OFF
LOW .= 1 MICROAMPS HIGH = 3 MILLIAMPS
EITHER POSITION CAN BE USED TO TURN ON
THE COLLOIDAL SILVER GENERATOR
LEFT LIGHT IS RED/GREEN BICOLOR LED THAT PULSES AND CHANGES COLOR EVERY 11.5 MINUTES TO INDICATE THE POLARITY IS SWITCHED
RIGHT LIGHT INDICATES WATER CONDUCTIVITY WHEN MAKING COLLOIDAL SILVER. DISTILLED WATER SHOULD NOT LIGHT UNTIL SILVER CONTENT IS SUFFICIENT
1 ELECTRO MIRACLE PULSER IN A CASE WITH A BELT CLIP
2 6 INCH AWG 14 SILVER RODS
1 2.5mm TENS PLUG TO PINS CABLE FOR PADS
1 3.5mm JACK TO ALLIGATOR CLIPS FOR SILVER RODS
1 TEFLON SCRUB PAD TO CLEAN SILVER RODS
4 2"X2" PREMIUM GEL TENS ELECTRODE PADS
1 9V ALKALINE BATTERY
The ELECTRO-MIRACLE PULSER is the inexpensive version of the $1000 Bodicharger and is based on research shown here which uses Electro Pressure Regeneration Therapy (EPRT) and has been used in the LOW position to reduce blood sugar, hypertension and in the HIGH position to help with diabetic wound healing.
In both switch positions it delivers the direct current at one polarity and after 11.5 minutes it switches to the opposite polarity for another 11.5 minutes. This process continues until you turn the device off. It is recommended to use this for 3 to 4 hours each day for 5 days a week and is without any adverse side effects. Continue for 2 to 4 months as desired.
The Electro-Miracle Pulser uses a 9 Volt Alkaline battery and is portable.
In the LOW position it outputs 5VDC at about .1 microamps (100 nanoamps).
In the HIGH position it outputs up to 40VDC at 3 milliAmperes
In either position you can easily make your own Colloidal Silver by plugging in the other jack and placing the silver wires in distilled water.